Questions tagged [synchronization]

The tag has no usage guidance.

29 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
174 views

Synchronization of BPSK with variable-length symbols (ISO 14443)

Does anyone have an idea how one would perform BPSK symbol synchronization if symbol length is allowed to vary? As dumb as that sounds, this is not a theretical question.The "Proximity" Type B NFC ...
3
votes
0answers
1k views

Synchronizing signals with different sample rates

I am relatively new to signal processing, so I am still missing some basic knowledge, but I am trying to improve as much as I can. I am trying to synchronize two signals with matlab using cross-...
3
votes
1answer
250 views

Why does signaling overhead for time synchronization scale up with the number of transmitter nodes in a multiple access system?

I was recently reading about random multiple access methods without time synchronisation (of the pure Aloha type). In this paper it is stated that, The need for transmitter synchronization is a ...
3
votes
0answers
404 views

Symbol timing recovery design

I am trying to design the Symbol timing recovery(#STR) block of #DVBS Receiver. These are the specifications Symbol rate ($f_s$) = $2\textrm{ MHz}$ Acquisition range = $10\%$ of Symbol rate ...
2
votes
0answers
233 views

Designing a PI filter for a Costas Loop

I am currently trying to implement a Costas Loop in order to demodulate a BPSK signal. Here is the reference block diagram I have been using to design the loop:Costas Loop Block Diagram I originally ...
2
votes
0answers
71 views

Detection over AWGN analysis disagrees with Monte Carlo simulation

I have a fixed vector $\mathbf{s} \in \{\pm1\}^m$ and a random vector $\mathbf{d} \in \{\pm1\}^m$. I send either $\mathbf{x} = \mathbf{x_1} = [\mathbf{s}\space\mathbf{d}]$ or $\mathbf{x} = \mathbf{...
2
votes
0answers
376 views

Software based synchronizing of multiple data streams/sensors with slightly differing sampling rates

Situation: I try to synchronize the data streams of multiple sensors (ADXL372) of the same type but with different data output rates. The data sheet states all sensors should have the same sampling ...
1
vote
1answer
61 views

Confused about the difference between frequency synchronization and phase synchronization

I am not sure if this is the correct place to ask this question but it looked like the most fitting SE site. I study software engineering and I am taking a course about networking, where ...
1
vote
0answers
20 views

In OFDM, does the parameter time offset is important if there is only one mobile in the cell?

I am learning about OFDM, and in my reading, I have noticed that (mentioned everywhere) synchronization is a very critical aspect of OFDM. Here, I am writing in the context of time synchronization (...
1
vote
0answers
30 views

synchronize adcs with neuronal network

if i have two adcs(analog to digital converters) sampling a signal. Is it possible to synchronize the two adcs with deep learning? as far as i know, with super-resolution on image processing it is the ...
1
vote
1answer
162 views

phase difference detection

For application of syncing sampling clock phase to carrier phase of received signal where the received signal is sampled with 10 times the carrier phase and modulated with the PSK shown in the figure (...
1
vote
0answers
207 views

Band-edge filtering for an RRC pulse-shaped manchester/biphase-encoded bitstream

Band-edge (derivative matched) filters can be used to generate an error signal for frequency locked loops (real part) or symbol timing loops (imaginary part). The derivation of the band-edge filters ...
1
vote
0answers
31 views

How does the M-law Synchronizer work?

Relatively new to DSP, I've came across the approach for phase-estimation of PSK-Signals x(k): My question is: What do we get by exponentiating the Baseband-Signal?
1
vote
0answers
286 views

Frequency Domain Variant of Pearson's Sample Correlation Coefficient?

Suppose that you need to find (i.e. acquire) $x_1$, a short data packet with a known bit sequence preamble (i.e. a PRBS BPSK), in $x_2$, quantized samples recorded from the output of an ADC. You don'...
1
vote
0answers
492 views

How can I perform timing recovery from the envelope of PSK signals?

I'm trying to reimplement FDMDV in GNU Radio, largely for educational purposes. It consists of 15 PSK subcarriers, 75 Hz apart, 50 symbols/sec each. The center one is BPSK and alternates phase each ...
1
vote
0answers
301 views

Symbol timing recovery algorithms

I am trying to implement the symbol timing recovery loop and for that I have chosen two algorithm to compare my results one is feedforward and Gardner TED. One thing that is confusing me is smoothing ...
1
vote
0answers
81 views

What effect does mutipath have on estimating optimal sampling time using the averaging method described therein

This question takes off from this question regarding syncronization of BPSK signals. For the sake of argument let us assume 10 samples make up 1 bit. One method currently suggested is break up the ...
0
votes
1answer
35 views

Costas Loop SNR

I've seen in literature that loop performance is inversely proportional to loop SNR. The higher the loop SNR, the lower the variance, the better the performance. My question is how do we calculate the ...
0
votes
0answers
34 views

Frame synchronization for single carrier burst applications in fading channels

I recently started to implement communication systems with software-defined radios in GNU Radio. In my system design, I am planning to transmit data in burst mode, the frames will be not sequentially ...
0
votes
0answers
45 views

Instantaneous Phase Synchrony with Multiple Signals

I've recently been looking at phase synchrony to measure the Phase Synchronization between signals (following tutorial at jinhyuncheong signal processing tutorial). I.e. for two signals, retrieve the ...
0
votes
0answers
39 views

Correcting large frequency offsets at very low data rates

Consider a typical BPSK system running at a baud rate of 1 kbaud/sec - the receiver needs to deal with severe frequency offsets, let's say up to +/- 1 MHz offset and that the frequency offset can ...
0
votes
0answers
133 views

Synchronization of tx and rx in sdr

I am implementing a FMCW radar using bladerf sdr: When reading the output from the vector sinks, the outputs are not synchronised.How should I synchronise them? is it possible to do so using gnuradio ...
0
votes
0answers
33 views

aperiodic auto correlation properties

I'm reading about PSC (primary synchronization code) in UMTS. It is a so-called Golay sequence. It is said it has a good aperiodic auto correlation properties. What does it mean (in terms of aperiodic)...
0
votes
1answer
101 views

Symbol synchronization with unknown symbol rate

I'm learning about the early late gate symbol synchronization and understand that it needs to be given the symbol rate ahead of time. How could a multi-symbol rate system use an early late gate? It is ...
0
votes
0answers
388 views

How is DJI OcuSync wireless link physical layer implemented?

I'm looking for documentation on the wireless command link of the DJI OcuSync. I found this website (in Chinese). It seems like an OFDM link that uses Alamouti codes? I'm specifically interested in ...
0
votes
1answer
341 views

How to find a know signal in another signal which contains other signals along with the signal i need in python

I am working on BPSK with sound waves a carrier waves. Actually I am modulating my data with some known sync bits along with the information I need to send. So the things I will be having at ...
0
votes
0answers
100 views

"Time To Lock" in Bit Timing Synchronisation

In the context of bit timing synchronisation in digital communications, what is meant by the requirement that says the "Time to lock to a sampling point should be no more than X symbols"? There seems ...
0
votes
0answers
3k views

How to compute transfer function (Frequency Response Function) from experimental data

I have a set of data, in the freqeuncy domain, corresponding to a structural test. I have amplitude, phase and frequency for both the measured output and the input signal (accelerations are measured ...
0
votes
0answers
370 views

Sampling Clock Offset estimation

I want to estimate sampling clock offset. I am currently referring this paper " CRAMER-RAO BOUNDS FOR DATA-AIDED SAMPLING CLOCK OFFSET AND CHANNEL ESTIMATION ". Is there any other method to estimate? ...