Questions tagged [nyquist]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
6
votes
8answers
9k views

Nyquist Frequency Phase Shift

The figure below shows in dashed lines sinusoidal signals of the same frequency at three different phase shifts. The signals are then sampled such that the sinusoidal frequency is exactly a half of ...
0
votes
2answers
330 views

Why do we follow Shannon's Theorem in audio sampling?

My professor told me that in sampling a signal, is not usual to respect the Shannon theorem because the interpolation formula contains sines and fractions which are difficult to calculate with a ...
3
votes
2answers
322 views

Ignoring Nyquist

What happens if I ignore Nyquist? I have a 16.368MHz digital signal coming out of a GPS front-end chip. My microcontroller (which is reading that digital stream of data) operates at a maximum of ...
4
votes
1answer
9k views

How are signal bandwidth and MSPS related?

In various software defined radios, there are three important parameters to set when receiving: frequency, bandwidth and MSPS (million samples per second?). What does it mean to receive with a triple ...
3
votes
2answers
1k views

polyphase sample rate conversion with non-integer factor

I want to do sample rate conversion by subsequently upsampling with factor I=5, and then downsampling with factor D=9. I have designed a nyquist sample rate conversion filter h() of length M, with ...
4
votes
5answers
755 views

Regarding the Nyquist Criterion

I recently read that with compressive Sensing it possible to sample the signal at a rate lesser than that suggested by Nyquist Criterion. However, I am still not getting how this is possible. Can ...
1
vote
2answers
585 views

Where can I find an authoritative (peer-reviewed or textbook) reference to sampling-induced beating?

I presume we are all here well aware about foldback aliasing when sampling signals above the Nyquist frequency; i.e. half the sampling rate. By contrast, the phenomenon of beating occurs when ...
1
vote
3answers
3k views

What is the relationship between frequency vector and the peak frequency in FFT?

I am fairly new to both Matlab and FFT. I would like someone to explain to me the relationship between the frequency of the wave being processed, the number of point (usually called NFFT), the Nyquist ...
0
votes
2answers
8k views

what is the effect of variation of duty cycle of sampling frequency on a reconstructed signal

I have been asked to study an experiment which says "what is the effect of variation of duty cycle of sampling frequency on a reconstructed signal" I am not an electronics/electrical engineer I am ...
12
votes
4answers
2k views

Is there such a thing as band-limited non-linear distortion?

So if you generate a square wave by just switching a signal between two values, at sample boundaries, it produces an infinite series of harmonics, which alias and produce tones below your fundamental, ...
4
votes
1answer
1k views

What is “Equivalent Time Sampling” and what is it good/used for?

The literature on this method seems scarce, but I know that it has been used on radar systems to 'get away with' not having to sample nearly as fast as Nyquist would otherwise dictate, (at the cost of ...

1 2 3 4
5