Questions tagged [nyquist]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
5
votes
3answers
550 views

Absolute convergence of periodic sinc interpolation

An $N$-periodic complex discrete-time sequence $[x_0, \dots, x_{N-1}]$ can be resampled to an $M$-periodic sequence $[y_0, \dots, y_{M-1}]$ with $M>N$, using sinc interpolation: $$\begin{align}y_m ...
0
votes
2answers
1k views

Higher order harmonics during sampling

I am studying about the sampling theorem in conjunction for ADC. I got little confused while reading about aliased frequencies. I see that as per the Nyquist theorem, the sampling frequency (fs) ...
6
votes
8answers
9k views

Nyquist Frequency Phase Shift

The figure below shows in dashed lines sinusoidal signals of the same frequency at three different phase shifts. The signals are then sampled such that the sinusoidal frequency is exactly a half of ...
-2
votes
2answers
425 views

Amplitude modulation vs sampling rate? [closed]

As a sampled tone's frequency nears $f_s / 2$, amplitude modulation grows apparent: ("Actual" curve in grey; blue is what we get if taking samples (dots) "at face value"). This is ...
6
votes
4answers
3k views

Nyquist plot interpretation when curve hits the origin

I'm a bit confused about the interpretation of the Nyquist plot when the origin is part of the plot. In this case I'm not even considering closed loops, I'm just looking at the Nyquist Plot of a given ...
12
votes
4answers
2k views

Is there such a thing as band-limited non-linear distortion?

So if you generate a square wave by just switching a signal between two values, at sample boundaries, it produces an infinite series of harmonics, which alias and produce tones below your fundamental, ...
3
votes
2answers
3k views

Link between DFS, DFT, DTFT

My understanding of DFT is as follows For a signal $x[n]$ of finite-length, the DFT is DFS of the periodic extension, $\tilde{x}[n]$, of that signal $x[n]$ and also another way to view DFT is that it’...
0
votes
4answers
794 views

Nyquist Theorem - Why unique frequencies upto Fs/2 and not Fs? f+Fs is start of Aliasing

If any frequency, f, displays an alias at f + Fs, This shows that unique frequencies have a range of Fs. Why does Nyquist theorem say that actually there is only half of this with unique frequencies ...
1
vote
5answers
281 views

Positive and negative frequencies in DFT due to frequency folding, or due to negatively indexed frequencies?

When I look for the cause of the mirroring of frequencies in DFT output, I get two types of explanations: The first one which says the frequencies are mirrored because of the complex exponential ...
1
vote
3answers
85 views

Upsampling with time offsets

Suppose I have done 4x oversampling for a continuous time signal, but the successive sampling times have a linearly increasing offset. Specifically, the samples with indices {4k; k=0, 1, 2,...} are ...
3
votes
2answers
2k views

What is the proof of the equation for the aliased frequency fa = |R*n - fs|?

R (sampling rate) fs (signal being sampled fN (the Nyquist frequency) fa (aliased frequency) I was hoping someone could explain to me why this is true with a more mathematical proof. it seems ...
3
votes
1answer
277 views

Sample rates, Samples per Symbol, and Digital Pulse Shaping

Having some confusion about digital pulse shaping for complex baseband (passband) signals. The complex baseband linear modulation equation is $$s(t)=\sum_{m=-\infty}^{\infty}\text{Re}\{a_m\}h(t-mT)+j\...
2
votes
1answer
786 views

Shannon-Nyquist theorem reconstruct 1Hz sine wave from 2 samples

Lets say I want to set the minimal sampling rate to reconstruct a 1Hz sine wave, according to the Nyquist-Shannon theorem that states that the maximum recoverable frequency is Fs/2 i.e. we must sample ...
1
vote
5answers
1k views

Confusion regarding Nyquist Sampling Theorem

The first time Nyquist Theorem was mentioned in class. It stated that we should sample at twice the highest frequency content of the signal. Example: If we wanted to sample $\cos(2 \pi f_0 t)$, the ...
0
votes
1answer
5k views

Passband vs Baseband Bandwidth

Bandwidth is the difference between the upper and lower frequencies in a continuous band of frequencies. A key characteristic of bandwidth is that any band of a given width can carry the same ...
0
votes
1answer
218 views

One sided frequency spectrum (Matlab vs. Origin)

There are a lot of queries on fft frequency all over the web. I guess the following point not discussed anywhere explicitly. Hope someone can provide an insight here. If we have and even number of ...
6
votes
2answers
37k views

Difference between Nyquist rate and Nyquist frequency?

So I've been searched online and can't seem to find a clear cut answer to this question. From my understanding, the Nyquist rate is double of the maximum frequency of a signal which Nyquist frequency ...
3
votes
2answers
5k views

Bandwidth with complex sampling

On the transmit side, I have a 20 MHz carrier frequency carrying a signal with bandwidth of 40 MHz (so 0 Hz to 40 MHz, center at 20 MHz). On the receive side, I have a dual channel ADC with each ...
0
votes
2answers
2k views

Root raised cosine pulse shaping filter

What are disadvantages of root raised cosine pulse shaping filter in digital communications and why does it need to be improved? Links: Square Root Raised Cosine Fractionally Delaying Nyquist ...
9
votes
3answers
521 views

Signal values we will 'miss' between sampling instances during sampling of band limited signals

According to the Nyquist–Shannon sampling theorem, any continuous time signal with a bandwidth $B$ smaller than Nyquist frequency $f_N=f_s/2$ (with $f_s$ the sampling frequency), which is sampled at ...
4
votes
1answer
1k views

What is Faster Than Nyquist signaling?

Faster than Nyquist signaling is used to improve the spectral efficiency by reducing the time spacing (relaxing the orthogonality constraint) to pack more data in the same channel while tolerating a ...
3
votes
1answer
1k views

Nyquist Plot for transfer functions with poles at the origin

I'm learning Nyquist plots and something has been seriously bugging me when treating poles or zeros in the origin. Nyquist plots obtains information based on the argument principle which states "If f(...
3
votes
1answer
98 views

Use of the harris-Moerder Nyquist Pulse Shaping Filter

I became aware today through fred harris' excellent presentation at the DSP Online Conference (https://www.dsponlineconference.com/) of the harris-Moerder pulse shaping filter which was published 15 ...
1
vote
2answers
156 views

Confused on Pulse Filter Bandwidth and Symbol Rate Relation

***Still need help in 2021 - not fully clear still on Jan 20th *** I am confused about the relation between Sinc and Rectangle transform pair and how that relates the Bandwidth of Pulses, Bandwidth of ...
1
vote
2answers
587 views

Where can I find an authoritative (peer-reviewed or textbook) reference to sampling-induced beating?

I presume we are all here well aware about foldback aliasing when sampling signals above the Nyquist frequency; i.e. half the sampling rate. By contrast, the phenomenon of beating occurs when ...
1
vote
3answers
3k views

Explanation of binning in frequency analysis post-FFT

I am creating an Android app which records sound for t seconds at a sampling rate of 44.1kHz with a buffer size of 8192 (16 bit mono samples). I need to plot a ...
3
votes
2answers
324 views

Ignoring Nyquist

What happens if I ignore Nyquist? I have a 16.368MHz digital signal coming out of a GPS front-end chip. My microcontroller (which is reading that digital stream of data) operates at a maximum of ...
2
votes
1answer
51 views

Cross Domain Equivalent to Nyquist Sampling Theorem?

In attempting to answer this question by @Oliver here: What characterizies 'causality' for a finite FFT? I have considered the minimum requirement to avoid time domain aliasing in the Discrete ...
0
votes
1answer
2k views

A voice signal is band-limited to 3.3 kHz. What is the Nyquist frequency?

I'm having a some trouble with an assignment I have to do. I don't come from electrical engineering background and would appreciate any help I can get. "A voice signal is band-limited to 3.3 kHz. ...