Questions tagged [noise-cancellation]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
0
votes
0answers
32 views

How to cancel this noise to find numbers of DTMF tones?

Touch-tone telephones use a dual tone multi frequency (DTMF) scheme to encode key-presses as audio tones: I have a signal containing 10 number tones. I used frequency response to show what ...
0
votes
0answers
24 views

Techniques for removing noise aside from Spectral Subtraction/Statistical Method?

I am studying how to remove noise from speech audio and I figured the most common error in spectral processing comes in the form of musical noise. Now what are the techniques on reducing this ...
1
vote
2answers
114 views

Removing Noise from time across signal data

I am new to the field of signal processing. I have sensor data (Impedance across time), that output is like this. On the right side, I have a noisy signal portion in my data, marked by the red block....
0
votes
0answers
21 views

Capture the ambient sound

I sit in a cafe and start recording my voice, reading a poem. Then I sit at my room, at complete isolation, and I read the same exact poem once again and record it. Now, Considering I have these two ...
0
votes
1answer
79 views

Why is the error between the desired signal and estimated signal in the case of LMS filter remaining constant even after n number of iterations

I am giving white noise as input to an adaptive filter which is initialized to zero (value of filter coefficients of adaptive filter is 0). I am getting a desired response $d(n)$ by passing white ...
0
votes
0answers
25 views

removing noise using Scipy.signal.butter:

I am going to remove the noise from a brain recorded signal. It was a continuous recording and with sample rate=30kHz, it was digitized. So now it is a digital signal. I have written the code here ...
5
votes
0answers
30 views

Minimum statistics noise estimate - how to calculate the underestimation factor?

I have implemented a basic noise estimator using the minimum statistics method. Noise power estimate is obtained as a minimum of the short time power estimate within a window of subband power samples. ...
0
votes
2answers
73 views

how a signal for which calculate RMS can be filtered and have a fast settling time?

i designed a sinusoidal pwm amplifier (3KHz to 20KHz) that regulates its output voltage reading the RMS value of output current. The RMS is obtained squaring the signal sampled by AD converter @...
2
votes
1answer
71 views

Reduce noise of sensor by combining two

I've had the basics of signal in university but little real-life practice. I've got an acceleration sensor with a digital output signal (signed 16 bit value). This signal is a little noisy. The ...
1
vote
0answers
12 views

Effect of filtering on Energy of a Digital Signal

I am trying to detect (not remove) noise from the digital signal to get meaningful information out of it. The signal I need is in the frequency range of 0.1 Hz to 10 Hz. Anything beyond this is just ...
3
votes
4answers
858 views

Noise reduction using multiple recordings of the same signal

I have two (audio) recordings of one analog signal, I used two separate devices (smart-phones) recording from two different locations. Each recording device is pretty crappy, lot's of electrical hum ...
0
votes
0answers
32 views

Which filters can I use to remove Poisson Noise from data?

I have a (continuous) function f and a vector v with values of f over an interval of integers as components, v = [f(0), ..., f(n)]. v is affected from Poisson noise such that the components are not ...
1
vote
1answer
72 views

How to filter very low amplitude staircase signal from a background noise

I have a staircase signal of a specific pattern that is drowned in a background noise. The ratio of signal to noise amplitude is nearly $10^{-4}$. I have attached the image of both with this post. I ...
0
votes
0answers
42 views

Acoustic Echo Cancellation implementation on hardware vs software

We are currently doing DSP using a XMOS VSM01C chipset using the preinstalled AEC algorithms. However we are now at a point where we would like enhanced flexibility and customisability of the ...
-1
votes
2answers
166 views

how to remove noise from heart sounds?

i have .wav files acquired through putting android cell phone MIC directly on chest of person.For feature extraction, i have to made them noise free. These recordings were taken in rooms with no noise ...
0
votes
1answer
184 views

How can I reduce background noise from recorded audio conversation and separate speakers in python?

I have a recording of an audio conversation of two persons. I want to remove the background noise from audio and then also separate both persons' audio separately in python. I have gone through some ...
0
votes
1answer
77 views

Is there a noise cancellation technique for over-lapping spectra?

I understand Wiener filter is used to reduce noise, Gaussian noise as well, once we give the noise characteristic. One may derive the filter coefficient in adaptive way as well But can it remove noise ...
0
votes
1answer
59 views

how does the Frequency spectrum of a signal change in the logarithmic space?

I am trying to implement basic homomorphic filtering but I can't seem to understand what happens in the frequency domain when you take the natural logarithm of the function. In Matlab I'm getting not ...
1
vote
1answer
64 views

Intelligent Noise Removal in Data

This question is linked to this question: I have this data: ...
0
votes
0answers
120 views

Remove background noise from audio signal

I am looking for a python or matlab code to take an input audio signal, process it and remove any background noise other than the infant cry such as vehicle noise or a human talking noise and get the ...
1
vote
0answers
175 views

Feedback Filtered-x LMS algorithm: question about theory

I was reading some of papers about the Active Noise Cancellation; in particular about the Filtered-x LMS algorithm, also known as FxLMS. It seems that classic FxLMS (also called Feedforward FxLMS) ...
0
votes
1answer
86 views

How do I know what is causing the noise in my signal

I have a noisy audio file, available here (It is safe to download if you wish to) https://ufile.io/pstrt Now, I inspect it in matlab: And then i plot it on normalised frequency: Now I need to ...
0
votes
1answer
56 views

Cancelling out known signal with sampling offset

I would like to cancel out a known audio signal at my receiver. Specifically at my transmitter I am playing a song, and at my receiver I am recording it. Both transmit and receive sampling rate is 44....
1
vote
0answers
120 views

How to estimate noise by eigendecomposition of the variance covariance matrix?

I'm new here so I will try to be as clear as possible. I am trying to apply some techniques from signal processing framework to denoise financial time series. I would like to know if what I am ...
2
votes
1answer
1k views

Real time background noise reduction or removal

I am trying to build a real time simple audio recognition that can recognize few keywords. Following this tensor flow tutorial i was able to train a simple neural network. Currently the signal flow ...
1
vote
0answers
31 views

NLMS Echo Cancellation: How do we estimate when the time-step at which the Far-End Echo will be generated?

I'm new to this domain. From my understanding, we do the following in our algo: ...
-1
votes
1answer
416 views

Background Noise Reduction in Audio signal

I using high pass filter for reduction or removal of noise of audio signal but still some noise is there in signal.i have MIC,Head Set,Bluetooth and phone are connected to controller,while talking on ...
1
vote
1answer
179 views

Noise Characterization

i am working on characterization of noise in an experimental signal from an accelerometer, mounted on a beam. Normally, white gaussian noise is considered by several researchers to add noise in the ...
2
votes
0answers
94 views

Common mode signal cancellation on multi-channel system

I have a system consisting of 32 horizontal plus 32 vertical charge sensitive wires. They are part of a particle detector and each one is coupled to a charge amplifier consisting of preamp stage ...
2
votes
1answer
267 views

Hardware requirements for ambient active noise cancallation system using adaptive LMS

Background I'm working on a hobby project to reduce ambient low-frequency noise generated from HVAC equipment within a small area of a room. The noise is predictable and concentrated between 55Hz and ...
3
votes
1answer
435 views

Proof-of-concept for active noise cancellation to block consistent low-frequency HVAC noise transmission

Background We live in a multi-unit building where each unit's HVAC system/closet is located directly across a party-wall from the neighboring unit's bedroom, and adjacent to a shared external curtain ...
0
votes
0answers
67 views

Construct a signal that is multiplied by a white noise?

Can we reconstructs a signal after it is being multiplied (not added) by a random noise (not with the normal distribution)? Lets say I have S=10*sin(2*pi*5*t) for t=[0:.001:1] and I have a random ...
0
votes
0answers
60 views

Adaptive algorithm for active noise control

I'm looking at building a cost-effective active noise control system. Basically, the system comprises two microphones - one reference and one error. A DSP unit samples and phase flips the reference ...
2
votes
2answers
339 views

efficient Noise cancellation & suppression algorith to use in VoIP for low latency

I am working on Noise suppression and cancellation in VoIP media engine. I am looking for noise cancellation & suppression algorithms and its implementation available with real-time low latency ...
1
vote
1answer
460 views

Noise removal using adaptive noise cancellation algorithms in real time systems

I am newbie in signal processing. I want to remove noise from real time audio signal using adaptive noise cancellation(LMS&RLS) algorithms. I don't know how to choose reference signal(noise signal)...
-1
votes
2answers
2k views

ImageJ: How to remove image artifacts due to dirty camera lenses? [closed]

I have an image of interest and would like to remove the artifacts from it (black dots, which are probably dust on camera lenses). How can I do it using the ImageJ (FIJI)?
4
votes
1answer
1k views

Are there any open source libraries for Adaptive noise cancellation?

I'm creating a chat application where people can input text via speech and I need to implement noise cancellation using Adaptive noise cancellation technique. I'm using dual microphones for this ...
0
votes
1answer
2k views

Removing high pitch noise embedded in audio spectrum

I have an audio clip. Here is the clip in wave format https://www.dropbox.com/s/542jgpfk7bfkt01/sample.wav?dl=0 I chose the following area of time domain signal The spectrum of this signal shows ...
1
vote
1answer
142 views

Can I have some feedback on this research paper?

I have submitted this paper "Effect of Transducer Positioning in Active Noise Control" to arXiv. I would like to get some feedback on the methodology of the same. Inputs of any sort are welcome. Can ...
1
vote
2answers
741 views

Removing noise from PCM file [closed]

I want to implement basic noise reduction. I'm recording audio using a microphone mounted on a drone. I would like to filter the audio file from drone noise. What's the best way to do it ? My first ...
3
votes
1answer
418 views

Remove Noise from Physiological Signals [duplicate]

I have collected a set of physiological signals through emg sensors. I will link at the end of the post an example (10 sec.) of a signal collected on zygomatic muscle. When I analyzed these data, I ...
0
votes
1answer
71 views

Extract same in phase signal from 3 different sources with shared delayed noise?

If I have 3 signals coming from 3 microphones with noise $n$ delayed like this: $S_1(t) = x(t) + n(t+\phi_1)$ $S_2(t) = x(t) + n(t+\phi_2)$ $S_3(t) = x(t) + n(t+\phi_3)$ Their shared feature $x(t)$...
1
vote
1answer
35 views

Overview of regression methods between the data

I am trying to find different approaches (classic and modern) in order to find a regression function between data (in time domain) with high-frequency noise. Consider the result of this code (in ...
2
votes
1answer
105 views

What techniques/algorithms can I use to reduce noise when recording audio?

I'm making a handmade guitar chords dataset by recording 20480 samples of a 44.1kHz microphone to later on make a chord classification using CNN. But there's a problem... I'm making this dataset on my ...
1
vote
0answers
75 views

Signal chain for voice calls including adaptive noise cancellation, adaptive echo cancellation, and automatic gain control and their algorithms

I am trying to understand the entire signal chain and all the algorithms associated with adaptive filtering as mentioned in the case above. From my understanding: Adaptive noise filtering (ANF)- can ...
1
vote
0answers
718 views

Noise cancellation using RLS filter

I am trying to create an adaptive noise canceller using the RLS algorithm. The dsp toolbox from matlab offers the RLS adaptive filter already implemented, so this saved me some trouble. My goal is to ...
10
votes
1answer
2k views

How does noise reduction for speech recognition differ from noise reduction that is supposed to make speech more “intelligible” for humans?

this is a question that has interested me for some time now, mainly because I'm working on noise reduction for an existing speech recognition system myself. Most papers on noise reduction techniques ...
0
votes
2answers
443 views

Why use cross-spectral density to calculate frequency response?

I am taking a class about system identification and currently learning about cross-spectral density. My textbook says that the frequency response, G, of a system can be determined as $$G=\frac{S_{uy}}...
1
vote
0answers
176 views

Fixed point Error Spectrum Shaping (noise shaping) for biquads

Based on that article and all the resources on the internet that advise the use of noise shaping for fixed-point filter implementations, I tried to make a few simulations on Matlab for the biquad I'm ...
2
votes
2answers
283 views

Magnetometer coil equalization

I have a search coil magnetometer with two coils, one at each end of a ferromagnetic core of high magnetic permeability: Figure 1. Double search coil magnetometer. (Modified from a drawing CC BY-SA 3....