Questions tagged [gnuradio]

GNU Radio is a free software development toolkit that provides the signal processing runtime and processing blocks to implement software radios.

Filter by
Sorted by
Tagged with
2
votes
2answers
264 views

How to adjust receiver gains to avoid saturation and quantization noise to optimise post digital processing?

I am using a Hack RF One as SDR and the software GNU Radio to receive and process signals emitted from a drone. Given that the drone is moving and is emitting signals from a wide zone, received signal ...
0
votes
1answer
265 views

Emulating a Variable Delay

I am trying to emulate a satellite link where the delay time between the satellite and ground station changes over time due to the satellite's motion. I plan do this by converting to the frequency ...
3
votes
1answer
2k views

Pulse shaping with RRC : Number of taps

I am running a BPSK flowgraph in GNU Radio which is based on RRC pulse shape. I noticed that the BER is quite poor when the number of taps is low. However, using the number of taps around $20\times ...
3
votes
0answers
310 views

GNU Radio | Transceiver loopback adapted | Transmission stops unexpectedly

(This is a follow up question to a previous question: link) I have implemented a flowgraph of a transceiver loopback inspired by the examples found at ...
2
votes
1answer
1k views

GNU Radio | Packet Encoder/Decoder | Unwanted bytes added to the transmitted stream

(A follow up question can be found here: link) In an attempt to understand how the packet encoding blocks work I tried to mimic the experiment performed by Aaron, published in this post, but reduced ...
1
vote
0answers
463 views

How can I perform timing recovery from the envelope of PSK signals?

I'm trying to reimplement FDMDV in GNU Radio, largely for educational purposes. It consists of 15 PSK subcarriers, 75 Hz apart, 50 symbols/sec each. The center one is BPSK and alternates phase each ...
0
votes
1answer
2k views

FFT scaling in GNU Radio

In GNU Radio Companion, I have created a very simple flow graph where I generate a 1 kHz, 2.0 volts peak-to-peak sine wave, and feed it into an FFT sink and a time domain sink. The reference dB in ...