The Stack Overflow podcast is back! Listen to an interview with our new CEO.

The tag has no usage guidance.

78 questions
Filter by
Sorted by
Tagged with
28 views

### channel gain calculation

I want to calculate the SINR term in an up-link of wireless communication system but there is different models for simulation. I want to know what is the exact meaning of |h|^2 in this formula: SINR = ...
22 views

### Detecting multi-path propagation when one acoustic signal is dominant

I am sending an acoustic signal from a source to a receiver where there are limited number of paths the signal can travel. I want to detect if there has been multipath propagation or not when one path ...
63 views

### Error detection and correction algorithms for Wireless Body Area Networks

I am working on transmitting ECG signals over wireless body area network based on IEEE 802.15.4 standard. To reduce the BER and increase the signal reconstruction quality, I think that I need to ...
55 views

### channel estimation for cdma

I am looking for a method to make a multi-user channel estimation with CDMA. Here is my question: Is there a way to estimate multi-user channels with their spreading codes? If yes, what is the ...
430 views

### Flat vs frequency selective fading in MC-CDMA?

I am trying to simulate an MC-CDMA system. I have NXK matrix $S$ which consists of subcarriers ($s_n,_k$ represents subcarrier $n$ of user $k$) and KX1 vector $X$ consists of user symbols. So my ...
31 views

### Assessing relative wireless channel quality using Capacity and Condition Number CDFs

I have Channel capacity analysis figures for two wireless channels show below: My question: While ergodic capacity in the first subplots are very clear in conveying the channel capacity, How to make ...
204 views

### Channel impulse reponse multipaths

I find this image : Does it mean that at 0ns there is one path, 10ns second path, ... and approximately at 130 ns, there is a power path?
103 views

### Performance evaluation in terms of channel MSE and BER

The first figure on the left (in this paper) provides the channel NMSE performance and the the second figure from left provides detector's BER performance. I am curious, when the channel MSE ...
545 views

### Cyclic prefix length in baseband OFDM with ZF equalizer

My question is about baseband OFDM. I try to plot the BER according to the SNR. I noticed that changing cyclic prefix length does not affect the performances. I.e., following the code below, ...
35 views

### SNR and Correlation

Signal to Noise ratio is essentially the ratio of the signal power to the average noise power. Correlation is the similarity of two signals. Assuming a signal travels through a channel or medium, and ...
89 views

### Equalizers with low data rate systems

In case of using equalizers with ZigBee systems, what type of fading does the channel show, flat or frequency selective, fast or slow? Is the inter-symbol interference (ISI) problem encountered in ...
37 views

### Validating Jakes model in Rayleigh Fading channels

I am trying to validate the Jakes model by comparing the autocorrelation function given by $\rho(\Delta t ) = J_{0}(2 \pi f_{d} \Delta t)$, where $f_{d}$ is the maximum Doppler shift, $J_{0}$ is ...
22 views

### Channel information from power spectra

Linked below is a previous post regarding a multipath channel. Equalisation of FFT spectra I am reusing the images here: The first image is that of the power spectra when there is no multipath and ...
520 views

I Read in one reference that, the Rayleigh distribution is commonly used to describe the statistical time varying nature of the received envelope of a flat fading signal, or the envelope of an ...
25 views

I am looking to simulate a radar channel and a waveform to test some ideas from other signal processing domains on automotive radar. However, I have no experience with the typical automotive radar ...
24 views

### What's the effect of spread spectrum on frequency- selective channel

In brief, we consider the channel as frequency-selective channel if the frequency of the signal is larger than then frequency of channel. So, does using the spreading spectrum change the frequency-...
59 views

### Explanation a flat fading channel in case MIMO OFDM

I am trying to understand flat fading and frequency selective channels. As I understood, in the case of flat fading channels MIMO channel elements, $h_{i,j}$, are random variables. Which assumption ...
82 views

### Digital communication BER performance

I've searched for the theoretical equations of bit error rate over Rayleigh flat fading channel basically for binary phase shift key and 16-Quadrature modulation but i didn't find them, could any one ...
30 views

### Frequency selective channel modeling using rayleighchan object in matlab

I intend to model a frequency selective channel using matlab "comm.RayleighChannel" object. Consider the following command, which sets the parameters of Rayleigh channel : ...
130 views

### BER of QPSK modulation in Rayleigh fading channel model

i am having trouble deriving a BER analytical expression for QPSK modulation system operating in a Rayleigh Fading channel model. Could anyone direct me to a reference that would help in this matter. ...
7k views

### Matlab: Correct method of generating Rayleigh fading channel

A Rayleigh flat fading channel has 1 tap and so there will be no intersymbol interference. if N= 1000; Then, h=(1/sqrt(2))*(randn(N,1)+1i*randn(N,1)); will ...
596 views

### How to compute the channel gain from the path loss model of a wireless channel

I did my research but I did not get a satisfying answer. We have a transmitter and a receiver over a wireless communication channel. The channel's path loss is modeled as $128 + 37 \log_{10} (d)$, ...
23 views

### Channel models for wireless body area networks

To transmit a signal over wireless body area network, the signal is transmitted over a fading channel with additive white Gaussian noise. The channel model can be obtained from the IEEE standards. My ...
107 views

### Channel model: LOS Component and Rician K-factor

I am asking about Rician K- Factor in this model: I know that if $K=0$ then it is a pure Rayleigh fading, if $K= \infty$, then non fading Channel. What is it, if $0<K<\infty$ ? If i represet ...
45 views

### Channel estimation

In single-carrier systems, at the receiver, when we need to do channel estimation and equalization? Do we need to do before timing synchronization and CFO correction or before it? And, please let me ...
42 views

### Designing Rayleigh Fading Wireless Channel with particular properties [closed]

I have some information on particular wireless channel between an Access Point(AP) and K users as described in the picture below: How i can create this channel in Matlab?
86 views