All Questions

Filter by
Sorted by
Tagged with
3
votes
2answers
258 views

Is maximizing hamming distance the same as minimizing correlation?

For the design of an error correcting code, I might wish to maximize the distance between the codewords $\sum a_i \oplus b_i$. For spreading sequences I'd like to minimize the cross-correlation at $t=...
0
votes
0answers
59 views

Find a simple sine wave buried within noise, FFT or cross-correlation?

My recorded signal x = s + v, where s = A*sin(ωt) and v = noise. SNR < 1 or ~ 1. So the sine wave is buried under a lot of noise. I need to compare the relative amplitudes of s for each recording ...
2
votes
1answer
1k views

Matched filter and cross correlation in digital processing

I am very new to signal processing, and a bit confused with the matched filter. Assume that I have a time series and a specific waveform I need to identify in it. By definition: a matched filter ...
1
vote
0answers
190 views

Frequency Domain Variant of Pearson's Sample Correlation Coefficient?

Suppose that you need to find (i.e. acquire) $x_1$, a short data packet with a known bit sequence preamble (i.e. a PRBS BPSK), in $x_2$, quantized samples recorded from the output of an ADC. You don'...
1
vote
1answer
295 views

Cross-correlation - Why is there a complex part after FFT/IFFT when deleting the mirrored part of the spectrum?

I want to detect a special shape in my time series and I apply an matched filter using cross-correlation to increase the SNR. ...
5
votes
2answers
789 views

How to calculate the phase shift AND time delay of non-periodic signals

Say I have two non-periodic signals, $f_1(t)$ and $f_2(t)$, with Fourier transforms $F_1(\omega)$ and $F_2(\omega)$. Basically, I need to line up $f_1(t)$ and $f_2(t)$ as close as possible, and I am ...
0
votes
2answers
502 views

matched filtering in GSM

After the estimation of channel impulse response (using the training sequence in burst), to cancel the effect of channel on the received signal, I think, we should convolve the received signal with ...
1
vote
0answers
362 views

Audio - TDOA and $\tt xcorr$, find the 'best' peak

I try to locate a mobile device using multilateration. The mobile device acts as the receiver and in the room I have three speakers. To calculate the position I need the time difference of arrival (...
6
votes
2answers
3k views

Detecting a Signal Inside a Time Series Using MATLAB's $ \tt xcorr() $

I would like to find the exact replica of signal A in time series B. I am working with the simple toy example below, in which A is located starting at the 4th position in B. I thought that using <...