Questions tagged [biquad]

Biquad is referred to either analog or digital second order filters

13 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
172 views

Issue with the Massberg Analog-Matched Low Pass Filter

Implemented the filter mentioned in title using Octave and couple sources Vicanek and Zeitlin (LPF.cpp). Got filter working otherwise but, ... when tested the responses against 'analog model' of the ...
1
vote
0answers
50 views

Is there any audio DSP without biquad constraint?

I found a codec with audio DSP, ADAU1772. It supports 32 biquads, that is $32\cdot5=160$ parameters. I need to calculate filter coefficients on-line. The result is in transfer function form, i.e., $...
1
vote
0answers
359 views

Biquad Filter Optimization

I would like to try optimize a bit more the biquad filters indended for RIAA/non-RIAA equalization at low samplerates (44.1/48kHz). Are there any open source optimization libraries (C, C++ or C#) out ...
1
vote
0answers
372 views

IIR biquad coefficients for negative frequencies in IQ data?

Assume I have a (single real float channel) biquad IIR filter implemented in C, and some coefficients for a bandpass filter (right out of RBJ's cookbook). If I convert the input, output, data path, ...
0
votes
0answers
63 views

Biquad Type-II Coefficient Generation

I have a Biquad II filter implementation in my embedded environment and I'm trying to find some equations to generate the coefficients for it. I have already found the Audio Eq Cookbook, which simply ...
0
votes
0answers
113 views

PeakEq center frequency does not match frequency response

Following the Cookbook i calculed these coefficients: ...
0
votes
0answers
251 views

Software implementation recipe of cascaded Biquad IIR filter

I have been given the task of measuring the performance of Biquad IIR filters on a new CPU that we are evaluating. What I know is that the Biquad filters can be cascaded to form higher order filters. ...
0
votes
1answer
342 views

Biquad coefficients using Magnitude (or Phase) Invariance Mapping Method

I'm trying MIM (Magnitude Invariance Method) and PIM (Phase Invariance Method) for to improve biquad LPF response at low sampling rates. I'm looking some help and examples of usage if available. ...
0
votes
0answers
185 views

Combining IIM and MZT transformation

Split from thread: Correcting Impulse Invariance Method Back to this subject. Matt L suggested combining IIM and MZT b-coeffs to get the filter response improved at hihger frequency area. Couldn't ...
0
votes
2answers
744 views

Regarding BIQUAD IIR implementation in MATLAB

I want to implement a high pass filter (order 4) in MATLAB using cascade form. ...
0
votes
0answers
670 views

Biquad high-pass filter - calculating filter slope

I have to design high-pass IIR Biquad filter with cutoff frequency of 80Hz, sampling frequency 24kHz, and filter slope of 24dB/oct @ 80Hz. I have used formula for HPF biquad coefficients from here. ...
0
votes
0answers
177 views

biquad decomposition from given magnitude response

I have a adaptive FIR filter of length 84 with magnitude response , which is close to low pass. (Please see the attached figure). I need to design filter that has a magnitude response opposite of the ...
0
votes
0answers
131 views

Second-order sections from complex coefficients

I have an impulse response ir that I need to approximate with an iir because of realtime requirements. For stability I want to break down the 10th order IIR generated with Steiglitz-Mcbride to biquads ...