The tag has no usage guidance.

10 questions
Filter by
Sorted by
Tagged with
8k views

### Nyquist Frequency Phase Shift

The figure below shows in dashed lines sinusoidal signals of the same frequency at three different phase shifts. The signals are then sampled such that the sinusoidal frequency is exactly a half of ...
781 views

### How do you simultaneously undersample and oversample?

"Undersampling" and "Oversampling" are common terms when referring to the choice of sampling frequency for analog to digital data conversion. Is it possible to Undersample and Oversample a waveform ...
367 views

### Higher order harmonics during sampling

I am studying about the sampling theorem in conjunction for ADC. I got little confused while reading about aliased frequencies. I see that as per the Nyquist theorem, the sampling frequency (fs) ...
762 views

### Quantization Noise for Coherent Sampling - Phase Noise?

Update: See added thoughts at bottom of this post. Under general sampling conditions not constrained by what is described below (signal uncorrelated to sampling clock), quantization noise is often ...
1k views

### How increasing the Signal to Quantization noise increases the resolution of ADC

Inside ADC we have a quantizer, when the sampled signal is passed through it, the signal values get discretized. The number of discrete levels in which the signal is discretized is called the ...
4k views

### Bandwidth with complex sampling

On the transmit side, I have a 20 MHz carrier frequency carrying a signal with bandwidth of 40 MHz (so 0 Hz to 40 MHz, center at 20 MHz). On the receive side, I have a dual channel ADC with each ...
300 views

### Frequency measurement from acoustic emission sensor data(VDC RMS)

Currently, I am facing a problem about understanding FFT concept and getting exact frequency with acoustic emission sensor data(VDC RMS data). I want to measure the sound frequency from the acoustic ...
53 views

### Moving average and linearization of two piecewise linear systems

I have 2 oversampling ADC's running parallelly, each to process data in a specific range of the input as shown below: Each ADC can process only half cycle range of a sine wave. Each ADC adds its own ...
I want to measure amplitude of a sine wave input precisely with a limited resolution ADC. As an example suppose that I have $1\textrm{ MHz}$ pure sine wave input to the $320\textrm{ Msps}$ $10$-bit ...