I have plotted the magnitude and the phase responses of an M-point moving average filter, the following are the plots when M = 10:

Magnitude and phase response for M = 10

We can observe that corresponding to every lobe in the magnitude spectrum we have a line in the phase spectrum - a linear phase response is observed corresponding to every lobe. (See the below picture)

Magnitude and phase responses with markings for M = 10

I tried to observe the magnitude and phase responses for different values of M and observed a similar pattern.

Is there any reason behind this pattern? Is there any significance for this?


1 Answer 1


The significance is a constant time delay for all frequencies. Time delay is the derivative of phase with respect to frequency, so given a linear phase as shown, the time delay is constant. Notice that the abrupt steps in phase actually only occur when the magnitude goes through zero so does not effect the nature of it being a "linear phase" filter.

An M-point moving average filter will have a time-delay (for all frequencies) of $M/2$, so if you increase the number of points, the phase slope versus frequency will increase.

Why do we like linear phase filters so much? Please see this post on that:

Why is a linear phase important?

Any finite impulse response (FIR) filter with symmetric or anti-symmetric coefficients (The OP's case with coefficients all 1 is symmetric) will be a linear phase filter.


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.