# peak limiting/audio compression formula needed

I'm looking for a formula to effectively compress an audio waveform to limit peaks. This isn't an "automatic volume control" application where one would control amplifier gain to maintain a volume level, but rather I want to limit ("soft" truncate) individual peaks. (I know this introduces harmonics, but I'm trying to analyze the data, not listen to it.)

My (very crude) formula so far is:

factor = (10 * average / level) + exp(-sqrt(0.1 * level / average))


Where level is the instantaneous sound level, average is the historical average sound level, and factor is a multiplier used to produce the "adjusted" level (factor times level).

Further, this multiplier is only applied if it computes to a value less than 1. Otherwise level is left unadjusted.

The intent is to limit the adjusted level to some multiple (about 15x with this formula) of the historical average. This formula is sorta what I need, but exhibits a "dip" as the numbers get larger. That is, the adjusted level (ie, factor times level) increases up to a point with increasing unadjusted level but then, rather than going asymptotic, begins to actually get smaller. (In fact, the first factor was added primarily to prevent the formula from going to zero with extremely high values.)

(The reason for wanting to limit the values this way is primarily so transient noise doesn't seriously upset the running average of the sound level. But when you're analyzing snores "transient noise" is quite significant, so I can's simply squelch it.)

So, can anyone suggest something better? (It seems that asymptotic behavior is easy to produce when you don't want it, but hard when you do.)

Two problems here: how to get a reliable estimate of the level, and how to compress the data.

• Use robust statistics on the original (not peak-limited) data like median or quantiles instead of a running average to make your "typical level" detection robust to outliers.
• $$k \times \tanh(\frac{x}{k})$$ works nice as a $$C^\infty$$ compression formula and it is actually what is happening in some audio circuits (using OTAs). To get adaptive compression that preserves the dynamics of the original signal and just remove transients, make k track the smoothed "average" level.

• Blue: original signal
• Green: 2 x median of the absolute value over a sliding window as a "typical level" detection
• Red: tanh compression (formula given above with k equal to the level plotted in green)
• Thanks, that looks promising. I'll plug it in and see how it does. Feb 10 '12 at 1:26
• I tried it out and it seems to be working well (after I cleared up a couple of finger checks). My only issue with it is that there doesn't appear to be any way to adjust the sharpness of the "knee" without mucking up the clip level or whatever. Feb 10 '12 at 22:58
• Why is "moving median" better than "moving average"? I read in many places that it's less sensitive to outliers. But I'm unable to see this with real data. Any idea about this question?
– Basj
Nov 27 '15 at 23:40